SCHEDULED -III See rule 11(3) LICENSING FORM FORM-LM-3 Office of the Controller of Legal Metrology LICENCE TO MANUFACTURE WEIGHTS, MEASURES, WEIGHING AND MEASURING INSTRUMENTS Licence number ......................... ...........................Year.................................................... 1. The Controller of Legal Metrology hereby grants to (name and address of party or parties): A licence to manufacture the following:- (Include details of the types of weights, measure, weighing instruments or measuring instruments that are licenced to be manufactured by the party). 2. The licence is valid for the party name above in respect of this workshop located at ........................... 3. This licence is valid from 1st Dec. to 31st December............................................................... 4. The manufacturer shall comply with the conditions noted below, if he fails to comply with any one of these his licence is liable to be cancelled. 5. The trade mark/monogram being used by the manufacturer is as under:- (Seal) (Signature), Controller of Legal Metrology Place.................................... Date....................................... Note:- In the case of firms, its name with the names of all persons having any interest in the business should be given in paragraph 1. CONDITIONS OF LICENCE 1. The persons in whose favour this licence is issued shall:- (a) Comply with all the relevant provisions of the Act and Rules for the time being in force ; (b) Not encourage or counternance any infringment of the provisions of the Act, or the rule for the time being in force ; (c) Exhibit this licence in some conspicious part of the premises to which it relates; (d) Comply with any general or special directions that may be given by the Controller of Legal Metrology ; (e) Surrender the licence in the event of closure of business and/or cancellation of licence; (f) Present the weights, measures, weighing or measuring instruments, as the case may be, manufactured and meant for use within the State to the Inspector for verification and stamping before sale ; (g) Present the weights, measures, weighing or measuring instruments, as the case may be, manufactured and meant for use outside the State and covered under the First Schedule of the Inter-State Verification and Stamping Rules, 1987 tod the Inspector for verification and stamping before sale; and (h) Submit the application for renewal of this licence, as required under rules before atleast thirty days of the date of expiry of the validity of the licence. 2. Every condition prescribed after the issue of this licence shall, if notified in the Official Gazette be binding on the persons to whom the licence has been granted. RENEWAL ENTRIES -------------------------------------------------------------------------------------------------------------------------------------------- Current No.............. .....................Date............................Current No........................Date..................... Renewed for....................................................................Renewed for........................... (Seal) Controller Seal Controller of Legal Metrology of Legal Metrology -------------------------------------------------------------------------------------------------------------------------------------------- Current No.............. .....................Date............................Current No........................Date..................... (Seal) Controller Seal Controller of Legal Metrology of Legal Metrology -------------------------------------------------------------------------------------------------------------------------------------------- Current No.............. .....................Date............................Current No........................Date..................... (Seal) Controller Seal Controller of Legal Metrology of Legal Metrology ------------------------------------------------------------------------------------------------------------------------------------------- |
|